Place the aggregator inside the machine’s power panel.
Mounting it closer to where you will connect the sensors will make the process easier.
Identify or create a port in the machine's power panel for the CAT5 cable to pass through.
Plug the CAT5 cable into the gateway, run it through the port, and connect it to the aggregator you mounted there in the previous step.
Clip the sensor over a wire carrying AC power to the motor performing the primary process of the machine (e.g. spindle motor power supply output).
If there are multiple wires for the 3 AC phases providing power to the same motor, pick any wire. The wire must only contain a single phase of power and not have a ground inside.
Plug the sensor cable into the aggregator’s first available port.
If you have multiple sensors, start at port 1 and plug the rest into the subsequent ports until they’re all connected.
Once you submit your machine configuration info, our team will begin tuning your machines and setting up your dashboard. This typically takes 1 week for pilots and 14-21 days for larger full deployments.